Support PWM pulse 1-2MS signal control that is standard servo control signal, Analog voltage signal control 0-5V, with normal servo function, and with 360 degree operating modes selectable , you can control the speed of servo
The servo build in  BEC 5V output, you can direct power to the receiver.
Parameter:
Power input: 12V-24V DC (V- connects with the cathode, V+ connectselectable operating modes, you can control the speed of servo speed.s with the anode)
No load current: <500MA
Maximum torque: 200KG.CM / 300KG.CM (24V) (actual, non theoretical value)
Angular velocity: 0.5S/60 degrees (60 degrees 0.5S), 24V
The rotation angle: 300 degrees MAX, mean maximum stroke of 300 degrees (0 to 300 degrees adjustable electronic limit)
Input mode: pulse signal (remote control, multi-channel servo controller, MCU) or analog voltage signal (potentiometer)
Pulse signal input range: 1.0ms-2.0ms
Analog voltage signal input range: 0V to +5V
Control and interface description:
Motor output (M+, M-): M- negative motor, M+ connected to the positive electrode
Motor speed adjustment input (LD): used to control the steering angle speed of the steering gear.
Angle adjusting input (XC): used to control the steering angle range.
Mode selection (VR): short circuit for pulse signal PWM 1-2MS input, short circuit to analog voltage signal input 0-5V; input default PWM
The steering mode (360): nonshorting for normal steering, short circuited 360 degree rudder; default normal steering gear
Analog control mode (5V-VR-GND): the angle of the input signal is analog, can use potentiometer to control the motor output shaft angle position.
Digital control mode (PW-5V-GND): the input signal is a digital Fang Bo signal, pulse width in 1ms-2ms.
Mode selection:
short circuit is analog voltage signal 0-5V input, if not short circuit, is pulse signal PWM 1-2ms input; the default input is PWM input.
Servo mode:
if short circuit, is 360degree servo; if not short-circuit, is normal servo; the default mode is normal servo.
Analog control mode (5V-VR-GND):
angle input signal is analog, motor output shaft angle can be controlled with potentiometer.
Digital control mode (PW-5V-GND):
input signal is square wave signal with pulse width 1ms-2ms.